Mechanical adjustments¶
Pedal face height, angle, force curve and tilt may be mechanically adjusted with the included Torx key.
Pedal face height¶
To adjust the height of pedal face:
- Loosen, don’t remove, the two (2) screws fixing the pedal, one on each side
- Adjust the pedal height
- Tighten the screws to approximately 3 Nm torque
Pedal face angle¶
To adjust the angle of the pedal face:
- Loosen, don’t remove, the four (4) fixing screws, two on each side
- Set the pedal angle
- Tighten the screws to approximately 3 Nm torque
Pedal tilt¶
- Loosen the two (2) screws on pedal subframe
- Move the now sliding subframe to desired position
- Tighten screws to approximately 3 Nm torque
Force curve¶
- Loosen the screw on pedal lever
- Move the now sliding joint to desired position
- Tighten screw to approximately 5 Nm torque
Spring replacement¶
1: Apply pressure to pedalface
2: Unscrew end stop
3: Release pressure slowly from pedalface and slide shaft assembly out
4: Remove spring
5: Remove plastic ring from spring
6: Install new spring by reversing the previous steps. Note that plastic ring should point to rear of the Throttle. Ring protects aluminium part from scratches.
Pre-installed spring is red curve on diagram, extra spring included in package is blue curve.
Preload & travel adjustment¶
Throttle has adjustments for preload & travel. Choose the positions according to your preferred feel.