Cabling

Overview of ports

All three available connection ports of the Simucube 3 wheelbase can be found on rear of the device. Port functions are listed in the table below:

Port	Description	Usage
POWER	DC power supply input	Connect to DC power supply
SC-LINK	Simucube Link port	Connect to Simucube Link Hub directly, or through Ethernet switch
Ctrl box	Port for Control box	Connect to Simucube Control box

Wheelbase installation

The illustration below demostrates how to connect a Simucube 3 wheelbase to a PC by using Simucube Link Hub (sold separately).

Note

Simucube 3 Wheelbase can not be connected directly to a PC. Simucube Link Hub is required for inputs to register.

Warning

To avoid damaging devices and prevent physical hazards, make changes to cabling only when DC power source has been fully unplugged from the mains input (house wall AC power socket). Powering off with POWER button alone is not sufficient.

Wheelbase + Active pedals

To connect multiple Simucube devices to a single Simucube Link Hub, such as Active Pedals, an ethernet switch is required. One such configuration with two Active Pedal Pros is demonstrated in the illustration below.